Technical Datasheet KSK-Abschlussband Self-adhesive, fabric laminated waterproofing tape
Material number
Contents
Packaging
Colour
205980001
1
Roll
Grey
Product features Finishing strip suitable for plastering over
Advantages Bitumen-compatible Highly flexible watertight Can be plastered over
Areas of application For securing the ends of the KSK waterproofing membrane For securing membrane ends of AQUAFIN-WM12 As a transition area to the plinth waterproofing For detail connections System accessory for KSK waterproofing sheet
Technical Data Material properties Product components Base material Tensile force, lengthwise in accordance with DIN 527-3 Tensile force, crosswise in accordance with DIN 527-3 Expansion, lengthwise (DIN EN ISO 527-3) Expansion, crosswise (DIN EN ISO 527-3)
Roll goods Butyl rubber with fleece lamination on one side approx. 30 N / 15 mm approx. 20 N / 15 mm approx. 50 % approx. 80 %
Application Substrate/application temperature
from 5 °C to 35 °C
Application technology Aids/tools Scissors/knife Pressure roller
SCHOMBURG GmbH & Co. KG · Aquafinstr. 2–8 · D-32760 Detmold (Germany) · Tel. +49-5231-953-00 · Fax +49-5231- 953-333 · schomburg.com 1/2
10/07/2023
Technical Datasheet KSK-Abschlussband Suitable substrate Cement plaster Masonry work Concrete
Substrate preparation Requirement for substrate 1. 2. 3. 4. 5.
Dry Load-bearing Even Sealed in the surface Free of adhesion inhibiting substances
Preparing the surface 1. Apply primer consisting of ASOL-FE (diluted 1:1 with water). 2. The primer must be completely dry / must have reacted fully before the subsequent work steps are carried out. 3. For transitions to cementitious waterproofing (e.g. AQUAFIN-RB400) a primer can be omitted.
Usage Application 1. Cut KSK-Abschlussband to the desired length. 2. Peel off the release film on the back and stick it to the end of the waterproofing membrane with an overlap of ≥ 8 cm and press on firmly. 3. KSK finishing tape can be coated or plastered over.
Storage conditions Storage Cool, dry, protected from sunlight. Min. 12 months in the original container.
Disposal Larger product residues must be disposed of in the original packaging in accordance with the applicable regulations. Completely emptied packaging must be returned to recycling schemes.
Notes Protect surfaces that are not to be treated from the effects of KSK-Abschlussband! Paints and plasters are usually not as flexible as the KSK finishing tape. Cracks in the area of the joint tape bonding can occur due to the different expansions and shrinkages. Store KSK-Abschlussband at room temperature (approx. +20 °C) until immediately before applying and only apply in dry weather. Negative water pressure cannot be absorbed by KSK-Abschlussband. Waterproof areas where this is expected with AQUAFIN®-1K. KSK-Abschlussband may not be glued or overcoated afterwards with products containing solvents. The KSK finishing tape is not suitable for permanent UV exposure and is to be plastered over, coated or covered after max. 3 months.
The rights of the buyer with regard to the quality of our materials are based on our terms and conditions of sale and delivery. Our technical advice team will be happy to advise you in the case of requirements that exceed the scope of the application described here. In order to be binding, a legally binding written confirmation is required. The product description does not release the user from a duty of care. Lay a test area in the event of uncertainty. This version becomes invalid in the event of a new version being issued.
SCHOMBURG GmbH & Co. KG · Aquafinstr. 2–8 · D-32760 Detmold (Germany) · Tel. +49-5231-953-00 · Fax +49-5231- 953-333 · schomburg.com 2/2