Share this page
back

Installation of tiles and slabs on chipboard and floorboards

Timber substrates must be clean, dry and load bearing. Chipboard must be laid bonded, screwed and glued. Faulty timber/board substrates are to be replaced, loose floor boards are to be professionally fixed (e.g. screws etc). Seal joints between boards, planks. Produce a gap between adjoining structures of min. 5 mm by inserting a self-adhesive edge insulation strip RD-SK50.

Print page
PRIMING

Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates

LEVELLING

Self-levelling fibre-reinforced cement-based floor levelling compound for wood substrates, min. 10 mm thickness

DE-COUPLING/INSULATION

Thermally insulating impact sound deadening and de-coupling board, 4/9/15 mm

WATERPROOFING

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

TILE INSTALLATION

Flexible natural stone adhesive

Rapid hardening, ductile flexible adhesive S1 for interior and exterior use

Accelerated hardening flow bed flexible mortar

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

GROUTING

Silicone sealant for movement joints

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Rapid hardening flexible grout, 3 – 20 mm joint width

Silicone sealant for discolouration-free elastic jointing