Share this page
back

Installation on old tiled finishes

The existing tiled finish must be sound and load bearing. Remove loose areas and repair with MGIII cement mortar. The substrate must be cleaned and all adhesion inhibiting components such as e.g. lime, grease, dirt etc must be removed. Resin repair cracks in the substrate with a reaction resin. Abrading the old tiling increases the bond of the primer or scratch coat.

Print page
PRIMING

Flexible mineral-based waterproof slurry as a scratch coat

Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates

WATERPROOFING

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

TILE INSTALLATION

Grey, highly flexible adhesive for interior and exterior use

Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use

GROUTING

Silicone sealant for movement joints

Simple to use grout, up to 6 mm joint widths

Silicone sealant for discolouration-free elastic jointing

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY